Auto glass repair kit Smart G02461
The Smart auto glass repair kit is perfect for repairing windshields and glass headlamps in an easy, quick and, above all, cheap way. Ideal for removing cracks and chips resulting from, for example, a stone impact. It works well when repairing chipping and small longitudinal cracks by effectively stopping further cracking of the glass. After application and drying, the adhesive becomes transparent, making the repaired area practically invisible.
Product features
- an easy, quick and cheap way to repair cracks and chipping
- the set is reusable
- effectively stops further cracking of the glass, reducing the stress at the crack site
- After drying, the glue becomes transparent, thanks to which the repaired place is practically imperceptible
- safe to use
How to use:
Use a red pin to remove the glass shards and clean the residue. Use a cloth
to clean the damaged area. Peel off the protective paper and adhere the
adhesive seal to the windshield, aligning the hole with the center of
the damage. Peel off the front of the adhesive seal and place the
O-ring seal in the center of the hole. Adhere the base to the adhesive seal,
ensuring the base opening is facing up. Use your thumbs to press firmly along the edges of the base
to ensure a tight seal with the seal.
Take the repair resin and cut off the top of the bottle. Gently squeeze the base of the bottle about three times.
You should have about 2 or 3 drops of resin (the amount needed may vary depending on the size of the damage).
Use a mirror to check if enough resin has been applied.
Screw the syringe onto the base opening, pull the plunger up, and lock it into the second clasp.
Hold the syringe in this position for 10-15 minutes to remove any air bubbles.
Unscrew the syringe from the base and screw it back on.
Push the plunger back into the syringe and secure it with the first latch.
Leave the syringe in this position for 10-15 minutes.
Unscrew the syringe and use a razor blade to remove the base and adhesive seal from the glass.
After removing the base, gently remove any remaining resin with a razor blade.
Apply 1 to 2 drops of resin to the center of the damaged area. Quickly place a hardening film over the damaged
area and use a razor blade to smooth the film, ensuring the resin is evenly distributed under the film.
If possible, secure the film with adhesive tape (not included).
The resin will naturally harden in 15-20 minutes in direct sunlight.
Once the resin has cured, remove the curing film. Holding the razor blade at a 45-degree angle, gently scrape off
any excess resin.
